GLUEGUN LOW PRESSURE MOULDING

Back to Hotmelt Glueguns

Low-viscosity polyamide adhesive is moulded at low pressure typically 3-35 bar, as a result low pressure hot-melt moulding techniques will not crush fragile connector designs or force material into connector environments.

 An Introduction to Potting, Encapsulation & Low Pressure Moulding

Sort By:
1 products in Gluegun Low Pressure Moulding

817 Black Granulated

Black, Low Viscosity, High Temperature Resistant, VO Rated, Zero Halogen, UL listed & ROSH approved Polyamide Adhesive.

 

MORE INFO